Updating firmware for linksys router emmanuelle chriqui dating architect


17-Mar-2016 14:28

NOTE: Replacing the factory firmware is different for every router.

In this example we will replace the firmware on a Linksys WRT54GL .

Be sure your computer obtains IP addresses automatically from your existing router or network via DHCP. Open a browser and type (login: admin, passwd: admin) 3. (In case of upgrading the original Linksys firmware, you MUST upgrade to the mini version of DD-WRT first). After the successful firmware upgrade, reset your router by pressing the reset button for at least 5 sec.

UPGRADE MUST NOT BE INTERRUPTED so please don't turn off the power or press the reset button. on the back of your router (little button on the back of the router).

Before I buy a new one, I wanted to try updating the firmware, as it is out of date.

I downloaded the file from the router's web page, and loaded it in the Administration tab of the router setup web page, but when I click the "Start to upgrade" button, I get a page that says 403 Forbidden: Your client does not have permission to get this this server.

After 3-4 minutes "Upgrade successful" will come up. Verify whether the router is doing a reset/reboot or not. If you cannot connect, then reboot your computer then try again. You should see the following screen: You must have to set a new username / password for the router's admin interface. Repeat step 4 and upgrade the firmware again with the standard generic firmware. Now you have a new firmware in your router, now you need to load your hotspot settings.

If the POWER light on the front of the router is starting to flash, then everything is OK. After 3-4 minutes "Upgrade successful" will come up. TIP: If you have troubles with the first step, please visit our troubleshooting page to find a solution to your problem.

updating firmware for linksys router-26

Freeadultchats

Owners and administrators of Linksys home routers are being advised to update and secure their devices following reports of active attacks on a flaw present in at least two models.According to the reports, the compromised routers scanned network traffic rapidly on port 80/8080, saturating available bandwidth, and in some cases their DNS settings were modified.



When I respond with a "yes", my questioners are usually puzzled.… continue reading »


Read more